TYPE HPAS Nylon PA6 corrugated, standard weight
X	Acetone
X	Benzene
X	Carbon Tetrachloride
X	Citric Acid
X	Diesel Oil
X	Diethylamine
X	Ethanol
X	Ether
X	Ethylamine
X	Ethylene Glycol
X	Freon 32
X	Lubricating Oil
X	Mek
X	Parafin Oil
X	Petrol
X	Sea Water
X	Silver Nitrate
X	Skydrol
X	Sodium Chloride
X	Sodium Hydroxide (10%)
X	Sodium Hydroxide (60 %)
X	Toluene
X	Transformer Oil
X	1,1,1-Trichloroethane
X	Turpentine
X	Vegetable Oil
X	Water
DESIGN CHARACTERISTICS
80N (18 lb)	for tubing ID less than 17 mm
156N (35 lb)	for tubing ID greater than 17 mm
-40 to 105°C	Temperature Range

X Provides good resistance to this substance * Data intended to indicate relative strength and will vary across different sizes. Figures shown for 21 mm nominal size.

IP Ratings Guide (Ingress Protection to BS EN 60529)
1st digit-protection against solid objects
0	No protection
1	Protected against objects greater than 50 mm
2	Protected against objects greater than 12 mm
3	Protected against objects greater than 2.5 mm
4	Protected against objects greater than 1.0 mm
5	Ingress of dust is not totally prevented but dust does not enter in harmful quantities
6	No ingress of dust
2nd digit-protection against water
0	No protection
1	Protected against falling drops
2	Protected against drops falling at 15 degrees
3	Low pressure spray - similar to shower head at up to 60° from vertical
4	Low pressure spray - similar to shower head - from any angle
5	Medium pressure jet - similar to garden hose - from any angle
6	High pressure jet - similar to fire hose - from any angle
7	Submersion at 1 meter for 30 minutes
8	Higher water pressure eg.: 5 bar for 5 hours. Conduits are tested in-house at up to 10 bar.
9K	Steam clean, high pressure high temp jet wash to DIN40050